Allis-Chalmers Model G Wartungshandbuch PDF herunterladen (Seite 33)

•. '" 0·.··

FUEL TANK

Removal.

Remove the hood,fend~~s' ~d seal'. Shut off

fuel valve under tank. Remove the-seat -and

the fuel line. R~movetlie-tank brackets f~om

the axle'housing~.·:·'/ --.' _.,-

Check the tank for leaking and accwnulation

of sediment. Clean if necessary.

Check the tank cap for vent hole cleanliness.

It must be open. Check cap gasket. It should

seal tightly.

If fuel tanks are to be soldered, use extreme

caution, or have it done by a competent

mechanic who understands the hazards of

such work and has the facilities to reduce

the hazards to a minimum.

FILTER

•..•• BAIL

FUEL FILTER

Shut off the fuel cock under tank and remove

fuel line, carburetor and fuel filter.

Clean the filter thoroughly. The filter is a

felt element and is very effective. If it

plugs rapidly it indicates better methods of

fuel handling should be employed.

Install the felt element with the web side up

and above the gasket. However, if it has

been installed upside down it is best to re-

place in same position, as dirt collected in

felt will be washed out and enter carburetor

if turned over. Dirt entering carburetor may

cause float valve leakage.

G - 30

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 44 45

Keine Kommentare

Allis-Chalmers Model G Wartungshandbuch Seite 33