Allis-Chalmers Model G Wartungshandbuch PDF herunterladen (Seite 3)

, j

,'-"'"

SERVICE MANUAL FOR THE tv«:>DEL''0'' TRACTOR

The {'ngine for the model "c'· tractor is mounted in the rear of the tractor.

For purposes of identification, the engine will be referred to as crank end.

flywheel end, manifold side and generator side. The No. I cylinder will be

at the crank end of the engine.

The design of the model "C'· tractor lends itself to a variety of procedure

for following practical repair work. The following general procedure may

be followed in removing major assemblies from the complete machine.

The complete engine may be removed as a unit. The engine must be removed

to do any repair work on the dutch, throwout bearing. flywheel or oil pump.

:.': The engine and clutch housing may be removed as a unit if the differential

is to be removed or the transmission dismantled.

Removal of the complete engine assembly or of the clutch housing must be

~a~e if the belt pulley drive gear or engine intermediate gears need ser-

vIcIng.

The adjustment of the transmission shaft bearings and removal of the special

low reduction gear may be accomplished if the to rque tube is removed from

tractor.

If the complete transmission and differential is to be repa'ired. the torque

tube, the engine, clutch housing and the two wheel axle aStiemblies must be

removed.

• • •

C - I

•

1 2 3 4 5 6 7 8 ... 44 45

Keine Kommentare

Allis-Chalmers Model G Wartungshandbuch Seite 3